The most common type of moisture sensor used in glove boxes has a probe head covered with a layer of phosphoric acid. The phosphoric acid deteriorates over time, which is why it needs to be renewed regularly (approximately every 2,000 hours). One of the manufacturers has created an instructional video (external link) on how to do this. In short, the phosphoric acid must be rinsed off with distilled water. Then, after drying the probe head, it is impregnated again with new phosphoric acid.

The principle behind this sensor is based on the fact that P₂O₅ is extremely hygroscopic - one of the most hygroscopic substances there is. This means that all the moisture is basically absolutely absorbed into. P₂O₅ then forms polyphosphoric acids with water until phosphoric acid (H₃PO₄) is reached. Therefore the probe head (Figure 1) is impregnated with phosphoric acid.